EDGE INDUSTRIAL EMZ

Appears New

5 HP - 1PH 56HZ - 3450RPM - 22 FULL LOAD AMPS AT 230V WILL REPLACE FRAME SIZES 143T / 145T / 56 / 56H / 56HZ ( THIS MOTOR WILL REPLACE MULTIPLE BOLT PATTERN CONFIGURATIONS) 3450 RPM - 22 AMP - 7/8" SHAFT Diameter ELECTRIC MOTOR FOR BELT DRIVEN AIR COMPRESSORS Capacitor Start & Capacitor Run Compressor duty motor Full Manufacturers Warranty + FREE SHIPPING to lower 48 states Same Day shipping if ordered 3PM EST Mon-Fri If you need help choosing the right motor to replace your old one. Please view our 5HP technical guide below. Technical Info: Horsepower: 5HP. Voltage: 230V ( Motor NOT rated for any voltage less than 208 VAC) Amperage: 22.0 fl amps at 230v Rotation: CCW Counter Clockwise Rotation when viewed from the shaft end. THIS MOTOR IS NOT REVERSIBLE RPM: 3450 Frequency: 60hz Shaft Diameter: 7/8" Keyed shaft Shaft Length: 2.25" Efficiency: 80% Service Factor: 1.0 Enclosure: ODP Open Drip Proof THERMALLY PROTECTED WITH MANUAL RESET Phase: One / Single Phase. 2 pole 5HP Motor Technical Guide: For all you "Do it Yourselfers out there" its vitally important that you match up the specs on your old motor, with the new motor you're purchasing. All 5HP motors are NOT created equal. A 5HP 56frame motor is drastically different than a 5HP 184T frame motor. Below is a quick check list for you to reference when sizing up the right motor for your application. All of the information you need to know can be found right on your electric motors nameplate/sticker. usually found on the side of the motor.

ORG5522646

10.0 inches

8.5 inches

54.0 pounds

17.5 inches

Appears New

835 Edwin C. Moses Blvd., Dayton OH 45417