ORISS

Brand New

3M VHB Tape 4910 is a general purpose adhesive with a firm acrylic foam core which offers a good balance of strength and conformability. It is a clear, 0.040 in (1.0 mm), general purpose acrylic adhesive on both sides of a firm, foam core. It can replace rivets, welds and screws. The fast and easy to use permanent bonding method provides high strength and longterm durability. It offers design flexibility with its viscoelasticity and powerful ability to bond to a variety of surfaces. Instructions: 1. Before using the tape, please clean the adhesive part, keep the adhesive surface dry, and avoid dust, oil stains, moisture, etc. 2. After tearing off the release paper, paste and press, stick the doublesided adhesive on the article and press back and forth. If there are bubbles, please press with your fingers to remove them. 3,When sticking with doublesided adhesive, apply force uniformly from one end to the other to reduce the appearance of bubbles. 4. Tear off the release paper, insert a needle or knife between the glue and the release paper, pry open a small hole, and then tear off the red release paper. 5. Wait for it to be firm, press hard after pasting the adhesive, and then bear the weight after 72 hours. NOTE: 1. The 3M doublesided tape is opposite to the stationery doublesided tape. The adhesive is not very strong when it is just pasted, so it is convenient for everyone to modify it when the wrong position is posted. 2. The tape will work best when it is pasted for 72 hours. Don't bear weight during this time. 3. The temperature in winter is low, if it feels not very sticky, it is recommended to use a hair dryer to heat it up. 4. Can not be used on litchi pattern surface, peeling, rough surface, or silicone material. Specifications : This is a custom bundle : Length 11 Yards, width 0.5inch, thickness: 0.040 in (1.0 mm).

LE

WEB3093337

7.1 inches

0.8 inches

0.4 pounds

7.8 inches

Brand New

1825 Webster Street, Dayton OH 45414

PAST PICK UP