YaeTek

Appears New

Installation Tips: 1. firstly please Install the pillar and tighten the screw. 2. Then please Install the dimension ruler. 3. Thirdly please release the wire,take it passing through the hole. 4. make the wire pass through the board hole, and buckle it in the spring. 5. Now Turn on the power switch and use the machine. Note: -Ajustable heating wire temperature, can cut different density and different materials -please kindly note normally the electric wire is not red, it's slightly red. if the wire is very red, cutting is not good. -When cutting, the wire temperature is high, please keep it away from flammable and explosive materials. -we recommend you to wear work gloves during cutting. -When complete cutting, please turn off the power switch in time, or it's dangerous. -Some materials may be smelly when cutting, we recommend you to cut in the ventilation environment. Description: - Adjustable temperature, heats up to approximately 300 degrees Fahrenheit witjin 1 minute. - This foam cutter cuts foam, sponge, also cuts round shape materials (iwth Dia.=340mm).With the regulator, could adjust 360 degree to make foam easily to be cut. And it could work consistently. - Brush to clean the wires. - Use screwdriver to install and remove wires from the heat cutter. Specification: -Good Temperature Stability - Table Foam Cutter - Voltage: 110V - Power: 30W - Temperature Range: 50-300 degree C - Max. Cutting Height: 20cm 8" abou Cutting Foam, Pearl Cotton, Sponge, KT Board, etc Package Included: - 1 X Table Foam Cutter - 1 x Power Cable - 1 x Cutting Wire (installed on the rail of the cutting machine) - 1 x Wrench Warm Notice: dear customers, if you do not find the cutting wire, please doulbe check, the cutting wire is installed on the rail of the cutting machine.

GRN4975699

4.4 inches

24.0 inches

16.5 inches

Appears New

967 Goodale Blvd, Columbus OH 43212