sixcow

Open Box

430-22011 Tilt & Trim Motor Replacement for Mercury Marine 135-225HP All Models Compatibility: Replacement for Mercury Marine Tilt & Trim Motor All Models 135HP 150HP 175HP 200HP 225HP 250HP. Also suitable for 2003 Mercury Optimax 200, Mercury Optimax 220 / 225 from 2000 to present. Mercury Mariner 0/B, Earlier Models Used 107-119m. Replace Part Number: 430-22011 Technique Information: Voltage:12 Volts Direct Current. Rotation: Reversible. Field Hsg OD: 75mm / 2.953in. Overall Length:124.7mm / 4.909in. Shaft OD: 8mm / 0.315in Approximate Weight:3.24 lbs / 1.47 kg. Installation Instructions Disassembly: 1. Remove the negative battery cable from the battery. 2. Locate the tilt trim motor on the outboard motor. Typically located on the port side of the engine and is attached to the hydraulic tilt and trim assembly. 3. Disconnect the wiring harness from the tilt trim motor. 4. Remove the two bolts that hold the tilt trim motor to the hydraulic tilt and trim assembly. 5. Carefully remove the tilt trim motor from the hydraulic tilt and trim assembly. 6. Inspect the tilt trim motor for any damage or wear, such as a cracked housing or a broken shaft. If the motor is damaged, it will need to be replaced. Installation: 1. Place the new tilt trim motor onto the hydraulic tilt and trim assembly. 2. Align the bolt holes on the tilt trim motor with the holes on the hydraulic tilt and trim assembly. 3. Insert the two bolts that hold the tilt trim motor to the hydraulic tilt and trim assembly. 4. Tighten the bolts securely. 5. Reconnect the wiring harness to the tilt trim motor. 6. Install the negative battery cable to the battery. 7. Test the tilt trim motor to make sure it is working properly.

430-22011DJ-US-1

EXS00969244

6.3 inches

3.9 inches

3.3 pounds

6.4 inches

Open Box

4140 Carothers Pkwy, Franklin TN 37067