SWEET HEAT

Open Box

About Sweet Heat Reflectors The highly reflective, aluminum surface bounces heat like rays of light, similar to how a flashlight uses a reflector to focus light in the direction you point it. The durable construction of our reflector means you get quality you can count on for the life of your heater. Sweet Heat Directional Patio Heater Reflector The Sweet Heat Reflector MAX is our 15" model that provides the most amount of heat and is the pinnacle of our heat reflecting technology. The Original Patio Heater Reflector. Our heat focusing reflector redirects heat where you want it, protects trees and walls from unwanted exposure, and saves on propane. Enjoy the perfect amount of warmth, while using the minimum amount energy! Make Your Propane Last Longer Extended Heat Range and Increased Performance Block Heat From Trees and Walls Fits Most Full-Sized, Round, Gas, Patio Heaters Made In The USA - Patent Pending Read more Tech Specs Height: 15 inches Width: 35 inches Weight: 2 lbs Materials: Aluminum Built to Last Every Sweet Heat Reflector is made with high grade aluminum and machined with precision. With functional design leading way, Sweet Heat is an absolute upgrade for your patio heater. Read more HOW TO INSTALL STEP 1 Prepare your Sweet Heat for installation by turning each of the thumb screws back slightly to open the gap. Make sure the gap is large enough to fit the rim of the overhead reflector on your heater. IMPORTANT: Prior to installation remove all packing material and peel film from the front side of the reflector. Do not remove the soft protective screw cap or the soft rectangular protective sleeve from the clamps. Those clamp protectors are made from high heat resistant materials. They are intended to stay on during use to increase clamp grip and help prevent scratches during installation. HOW TO INSTALL STEP 2 Make sure the heater is cool and shut off or disconnect the gas source prior to installation. Locate the gas control knob on your patio heater. As shown in the diagram, position the middle clamp of your Sweet Heat reflector on the opposite side or approximately 180 degrees from the location of the gas control knob. Place the rim of the heater's overhead reflector into the middle clamp. Tighten the middle thumb screw until it is snug. Overtightening is not necessary and doing so may dent your heater. Verify that the middle clamp of your Sweet Heat reflector is installed on the opposite side of the gas control knob as shown or adjust the location as needed. Failure to follow these instructions can result in heater damage and personal injury. HOW TO INSTALL STEP 3 Gently bend either side of your Sweet Heat toward the heater until the rim of the patio heater enters the clamp on that side, then proceed by tightening the thumb screw until snug. Repeat the same thing for the other side and you're all done! Check the thumb screws often to make sure they have not loosened up and are still tightly fastened to the heater top. To remove your Sweet Heat just follow these same steps backwards. Loosen the side clamps first and then remove your Sweet Heat after untightening the middle clamp. Just remember, never handle your Sweet Heat while it's hot. Touching your Sweet Heat while hot can result in personal injury. HOW TO INSTALL STEP 4 Always make sure all three clamps are fastened securely before turning on your patio heater. When ready to use, safely connect the gas and ignite your heater. Keep in mind that your heater will now deliver much more heat than it did before. Proceed with caution and do not stand or sit too close until you know how it performs. It may be best to start off with low heat at first to make sure you do not overdo it. Slowly increase the heat until you're comfortable. Please remember to remove your Sweet Heat when not in use and do not have it installed in windy conditions above 5 miles per hour. If a heater is not properly secured there is a heightened risk of tipping. Now sit back and enjoy the warmth! Review Clamp Parts Attach Middle Clamp Fasten Side Clamps Get Cozy INFRARED (IR) IMAGERY ORIGINAL IR images were taken to demonstrate heater performance in the setting shown above IR - WITHOUT SWEET HEAT The dark colors on the left indicate a prevalence of cold temperatures surrounding the patio table. IR - WITH SWEET HEAT The bright, glowing colors on the left indicate a prevalence of higher temperatures surrounding the patio table. Read more

GRN5566766

16.5 inches

2.5 inches

3.2 pounds

35.5 inches

Open Box

7660 School Road, Cincinnati OH 45249