FOUR UNCLES

Appears New

Pneumatic/Manual Oil Changer Instruction Step 1 .Preparatory Work The operating temperature is between 35 ° F and 200 ° F. Cool down the engine at least 15 minutes after driving. If the car has not been used in the past 4 hours, preheat for at least 3 minutes before extraction. Step 2 .Install The Tube Remove the cylinder cover, select a suitable tube to insert.If the hose is not long enough, connect an extension tube to the main tube, until it reaches the bottom of the oil pan. Step 3 .Extract Oil Pneumatic: Connect the 1/4" NPT quick coupler to the air compressor. Set the the operating pressure between 40-170 psi.Manual: Pump the fluid extractor with your hands. Get the job done anywhere and anytime.Make sure the tubes are connected tightly before extracting. Step 4 .Pour Out The Oil Press the decompression valve to release the negative pressure. Remove the hose clockwise.Pour out the used fluid to another container and take it to the nearby disposal center for recycling. Read more WARNING Do not extract the oil over the limit line on the tank, the bottom line helps prevent any spilling. If the fluid goes over the limit line, it might flow into the vacuum chamber and cause leaking from bottom.Noted that the fluid should not be over the limit line while pouring. Read more Features Long Enough to Reach the Bottom Extend the main tube by connecting with extension tube to reach the bottom of the reservoir, suck up every drop of oil. Iron Wire Make it Easier to Operate Insert the wire dipstick into the tube, hold up the soft hose strongly. 1/4” Air Inlet Connect to the air compressor, save effort and provide higher efficiency. Read more

JS--0011

RED5110274

9.4 inches

8.2 inches

7.6 pounds

23.4 inches

Appears New

967 Goodale Blvd, Columbus OH 43212