Facon

Good Condition

Upgrade Version: The modelCW-T1218 works efficiently up to 50 gallon holding tanks The heater pad comes with a fuse and owner's manual make you understand and install Facon heater pad products easily. The connection must be fused with correct amperage. If your RV power wire does not include the fuse , please use the fuse we included in this package. RV Tank Heater Pad RV Tank Heater Pad Elbow Pipe Heater Pad Elbow Pipe Heater Pad Bathroom Mirror Demister Pad Bathroom Mirror Demister Pad Size 7'' x 25'' 8'' x 25'' 3'' x 13'' 3'' x 8'' 10'' x 10'' 16'' x 11'' Voltages 12V DC 120V AC 12V DC 12V DC 12V DC 12V DC Usage For RV holding water tank For RV holding water tank For 3'' Elbow Pipe For 1 1/2'' Elbow Pipe For Square Bathroom Mirror For Rectangle Bathroom Mirror The Pad size 12'' x 18'' works efficiently up to 50 gallon holding tanks Properly sized and installed Facon Heater Pads provide consistent & efficient protection as the first signs of freezing winter weather approach Specifications: ModelCW-T1218 Pad size (Inch): 12" x 18" Foam Pad thickness: 3.0MM Volts : 13.5 V DC Power:65 W Electric Current: 4.8A Lead Wire Lengh: 36'' With Automatic Thermostat Control Built in thermostat is set to turn itself on at 45°F( + - 5 degrees) and turn itself off at 68°F( + - 5 degrees). Please wire it to on&off; wall switch in your RV Camper for easy control. As long as the on/off switch is in the on position and electrical power is supplied, the thermostat will continuing cycle preventing freezing. DON'T connect this modelCW-T1218 to 120V AC power supply. User's Tips: 1.Do not Stretch the pad. 2.Apply tank heater pads to smooth and clean surfaces. 3.Identify the lowest point on the holding tank, closest to the drain. 4.Clean the surface of the holding tank with isopropyl alcohol and let dry. 5.Peel back the paper from the adhesive, and then press firmly and smoothly over the intended placement area. 6.The model CW-T1218, requires 12V ~ 13.5V DC to operate . Don't connect this model to 120V AC power supply. Please ensure the connection to the proper voltage and the proper “on/off” switch is used. 7.The connection must be fused with correct amperage. The fuse connection please refer to drawing here. Please use 10A fuse for CW-T1218 Tank Heater pad. 8. Red Wire=Positive(+). Connect to RV power wire; White Wire=Negative(-). White wire can be wired to the metal frame on your RV / Camper, or if your RV / Camper has negative wire, then you can connect this end to negative wire. Please refer to drawing here. 9.Please ensure after installation the lead wires are securely located and will not hang below the surface of the tank. 10.If two or more heater pads are to be used they must be connected parallel.

GSHP-1218T-3

EXS01304643

12.5 inches

1.0 inches

0.7 pounds

19.2 inches

Good Condition

1311 W Main St, Lebanon TN 37087