HQUA

Good Condition

More and more people have chosen to invest in their own water treatment systems to cope with the increasing potential dangers caused by water contaminants in private and municipal water sources. Giardia, Cryptosporidium, and e.coli are considered to be the main microbe problem that are often found in private water sources, which could cause illness in humans. Most people are aware of e.coli, as it’s often discussed in media as a food contaminant, but it is also a water contaminant. The UV water purification system is considered to be an effective equipment work on these problems. Not only provide better taste, but also provide additional insurance for your family health. How it works? The ultraviolet (UV) treatment process is an extremely quick physical process. Ultraviolet light mutates and/or degrades DNA. When the DNA is damaged, the organism becomes unable to function because its “instructions” are garbled or missing. An organism that has no instructions cannot function and reproduce, and cannot cause infection. It is rendered harmless and eventually dies. In the UV disinfection process, water is purified as it runs through a stainless steel chamber (also called a “reactor”) that contains a special UV- producing lamp. As the water flows past the lamp, the microbe in the water receive a lethal dose of UV. HQUA UV Water Purifier is a water treatment device that needs to be assembled, but it’s easy to finish. Each part of it have its own function, we will introduce them hereby: Main Components Of The HQUA UV Water Sterilizer. UV Reactor Chamber The UV chamber is made by 304 stainless steel, which was widely used in food industry, medical, considered to be stable and durable. Length-21 inch, diameter-3.5 inch, inlet/outlet 3/4” DN20 1.05 inch/ 26.67mm , no requirement of the water flow direction. UV lamp & Quartz sleeve Quartz sleeve (HQUA-TWS- 12Q) not only provide an interspace for the UV lamp, but also ensure high transmittance (90%) for the UV light. UV lamp (HQUA-TWS-12L, GPH436T5L/HO standard 4-pin) provide enough UV light to destroy the DHA of the microbe and bacteria. Electronic Ballast Electronic ballast (HQUA-TWS-5595EB) connect the UV lamp and the power (120V/60Hz), work as a controller in the system with 3.2 ft. (100cm) power cord and 3ft. (90cm) lamp cord. Green light on ‘work’ means everything alright, red light blinks on ‘fault’ and the controller beeps when the system is failed. Read more Go Green and Satey Environment-friendly and safe sterilization treatment. Lack of chemicals means no harmful chemical byproducts are going back into the environment. And it avoid the potential threat residual chlorine, the taste of your water is not affected in any way as well. Effective Sterilization HQUA water sterilizer ensure a 99.99% reducing of bacteria and microbe in the water. The corresponding UV exposure is 30 mJ/cm². A slower flow rate, a higher wattage device or two sterilizer might be effective to handle a strong bacteria and microbe problem. Installation and Maintenance Easy installation and maintenance. No need for chemical supplement, the equipment is intended to be installed in the pipe system permanently. the lamp needs to be replaced annually and the quartz sleeve should be cleaned every 6-12 months, replace every 2 years. After-sales Service Excellent after-sales service. A lot of good reputation has accumulated on Amazon. Good communication experience and free replacements that helps many customers. Read more Please CHECK YOUR BOOKLET in the package before you handle this system. Please make sure you know what are you buying. NOTICE: Pre-treatment: Water quality is extremely important for the optimum performance of your UV system. The following levels are recommended : Iron < 0.3 ppm (0.3 mg/L)Hardness< 7 gpg (120 mg/L)Turbidity < 1 NTUManganese < 0.05 ppm (0.05 mg/L)Tannins < 0.1 ppm (0.1 mg/L)UV Transmittance> 75% Water pressure & Air temperature Maximum operating pressure 125 PSI (862kPa)Maximum ambient air temperature 122°F(50°C)Minimum ambient air temperature 32°F?0°C? Hot Water Warning The water in the chamber of this equipment can be very hot (Approx 140F) during an extended 4 hours of no water flowing. It's recommended to open the faucet until the hot water has been purged from the chamber. Keep human body away from the faucet during this time. Or install a 5 gallons water tank after the UV unit to reduce the temporary hot water. Maintenance UV lamp: Replace the UV lamp annually (or biennially if seasonal home use) to ensure maximum disinfection.Quartz Sleeve: Clean the quartz sleeve every 6-12 months, replace every 24 months. The coating on the quartz sleeve will slowly form due to the minerals in the water. This coating must be removed because it reduces the amount of UV light reaching the water, thereby reducing disinfection performance. If the sleeve can not be cleaned, it must be replaced.

hqua-60671998

YEL6613025

10.0 inches

6.0 inches

8.5 pounds

24.7 inches

Good Condition

8485 Broadwell Road, Cincinnati OH 45244