TSB

Good Condition

OEM PART No retail box and no install instructions, have a certified technician install all parts to prevent product damage and personal injury. NO Mounting Hardware DO NOT Exceed Capacity Single Motor System 2,500 lbs. per leg / 5,000 lbs. System LANDING GEAR LEGS - view photo diagram LANDING GEAR MOTOR 12 VOLT ONLY Two wire installation - one ground and one lead - Reversible (reverse the polarity of the wires) Turns 5,500 R.P.M. Internal Gear Box Turns at 190 R.P.M. Output Torque Powerful 12V gearbox providing approximately 150 in-lbs of output torque Clutch protected to prevent system overloading See Install Instructions Output shaft is designed to accept ½” shaft with roll pin (this is the industry standard) Motor mounts with 2 bolts that are provided ONE SWITCH PER MOTOR NEEDED MOTOR CLICKING SOUND this is the safety clutch in the motor preventing damage to the motor. This is not the gear box.When clutch noise occurs, release the power switch. Failure to do so will result in damage to motor and possibly other system components. 3:1 REDUCTION GEAR BOX RATIO Cast Aluminum Casing Heavy Duty Cast Gears CAUTION & SAFETY WARNINGS NEVER allow anyone unfamiliar with the operating instructions to use this product. Potential damage to the trailer frame may occur if legs or power kits are operated unevenly. Front of trailer must remain horizontal. NEVER position any part of body under any portion of the jack or the load. Do NOT use these landing gear jacks to lift trailer for servicing or tire changes. Do NOT attempt to lift or level without having both foot plates properly installed. SECURE trailer from rolling AVOID side force Do NOT attempt to adjust the drop legs when the landing gear jacks are under load. NEVER position any part of body under any portion of the jack or the load. Do NOT drop trailer off the hitch. RETRACT jack legs and drop legs fully before moving the trailer.

BLU6633233

20.0 inches

6.0 inches

38.0 pounds

33.0 inches

Good Condition

1200 NW O Street, Richmond IN 47374